Factors such as [10. For honeycomb activated carbon, the wall thickness is a very important parameter, by changing the wall thickness to improve its adsorption efficiency. Under the same porosity, thickness increases, the honeycomb carbon content per unit volume also will increase, which can improve the adsorption capacity. This is because the wall thickness increases, the fluid channel in the cellular cross-sectional area reduced, so the real surface or volume flow rate will increase. At the same time, the contact between adsorbate and carbon efficiency will, there is a balance between the two. Under the given conditions, the balance will determine adsorption increase or decrease. If the adsorbate at higher the diffusion rate diffuses to the inside of the honeycomb wall, and the empty adsorption site can be continuously adsorbed, so the thick-walled honeycomb should have better adsorption efficiency and adsorption capacity"Determination of air velocity and cross-sectional area of empty towerThe empty tower gas velocity is the velocity of gas passing through the entire cross section of the adsorber.The selection of air velocity not only directly determines the size and pressure drop of the adsorber, but also affects the adsorption efficiency.
activated carbon for gold miningTaking coal as raw material to the production of coal based activated carbon is a kind of has a developed interspaces structure of carbonaceous adsorption material, has good chemical stability and mechanical strength, coal based activated carbon products can be widely used in decoloring purification, solvent recovery, gas separation, gas purification, and various kinds of water treatment and other fields, some through special processing, the special T also can be used as a high-performance activated carbon desulfurization agent, catalyst and catalyst carrier, mountain in the acid and alkali resistant, heat resistant, granular activated carbon on adsorption saturation after failure, can be a party to regenerate.Physical - chemical methods include thermal destruction, photodecomposition, corona, ozone decomposition, etc.Biological methods include biological filter, biological drip filter, biological scour tower, membrane bioreactor, activated sludge process, etc.The purification rate of activated carbon adsorption method can reach more than 95%, if there is no regeneration device, the operation cost is too high, if the steam recovery, the process is too long, the operation cost is high, the recovery of solvent and water mixture utilization value is not high;Regeneration needs a stable steam source, and the adsorption capacity of activated carbon after repeated adsorption and desorption will gradually reduce, generally use two or three years after the replacement.The purification rate of liquid absorption method is only 60%-80%, and there are secondary pollution problems.[url=https://www.chinactivecarbon.com/]activated carbon suppliers in china[/url
Stránka 1 z 17: 2 3 4 5 ... 13 14 15 16 17 Next »